Home > Masonry > Shop By Project Type >

MasonrySaver Water Repellent for Split-Face Block - 5 Gallon
MasonrySaver Water Repellent for Split-Face Block - 5 Gallon


 
Our Price: $199.65

Availability:: Usually Ships in 24 to 72 Hours
Product Code: 0905722105
Qty:

Description
 
MasonrySaver Water Repellent for Split Face Block is a waterborne block sealer that causes water to shed, and significantly reduces water penetration into a wall system. It is specifically designed for lightweight, split face and fluted block.

This product is a silane/siloxane blend with acrylic elastomers that penetrate small pores and reduces the size of larger ones. This combination gives MasonrySaver Water Repellent for Split Face Block the advantages of both a film forming coating and a hydrophobic silane/siloxane water repellent.

UV Stable

This UV stable product allows for penetration of up to 3/4 of an inch or more depending on porosity of the concrete masonry unit. This creates a deep, long-lasting waterproof zone within the surface while producing only a minimal glossy look.

Recommended Uses

This product is recommended for use on all porous, vertical, above grade concrete masonry units including:

  • Smooth block

  • Split-faced block

  • Burnished block

  • Fluted block

  • Ribbed block

  • Concrete

  • Brick


Natural substrate color and surface textures are only minimally affected, adding only a slight sheen and darkening. It can be used on denser clay brick where some gloss and sheen are desirable.

MasonrySaver Water Repellent for Split Face Block can be painted over with most quality oil base paints that are recommended for exterior masonry surfaces. Coverage rates will range from 40-125 square feet per gallon depending on surface porosity. Product dries to the touch in 30 minutes to 2 hours depending on temperature and humidity. Testing is recommended before treating any surface to ensure desired results.

Share your knowledge of this product. Be the first to write a review »